چگونه می توان دریفت ماشینکاری سوراخ عمیق را حل کرد؟

Nov 01, 2021

در فرآیند ماشینکاری سوراخ عمیق به دلیل خطای تقارن دو لبه برش مته و ناهماهنگی تیزی و ... باعث رانش موقعیت سوراخ در حین حفاری می شود. تحت شرایط عادی، کنترل مقدار رانش 100 میلی‌متر در 0.1 میلی‌متر دشوار است. به طور کلی، سوراخ‌های سخت‌تر پس از حفاری باز می‌شوند. ریمینگ می تواند دقت قطر سوراخ را کنترل کرده و کیفیت سطح را بهبود بخشد. اما نمی تواند رانش ناشی از حفاری را اصلاح کند.

برای حل این مشکل، ما تفکر مرسوم را شکستیم و معتقد بودیم که اگرچه رانش در حین حفاری اجتناب ناپذیر است، اما هنوز هم می توان با تطبیق دایره بیرونی با سوراخ داخلی، نیاز هم محوری را تضمین کرد. مراحل فرآیند خاص راه حل رانش موقعیت سوراخ ماشین کاری سوراخ عمیق عبارتند از:

(1) خالی کردن، یک حاشیه 2 میلی متر برای طول کل باقی بگذارید.

(2) The left end of the car is exposed to light, and the outer circle of the rough car is φ35.5mm.

(3) Clamp the outer circle that has been rough-turned at the left end, and finish turning the right end face to ensure that the total length is 80±0.05 mm, and drill and ream through holes of φ4.9±0.05 mm.

(4) Remove the burrs at the two ends of the hole, two holes with φ4.9±0.05 mm, and the outer circle of φ34.9 mm is finely turned.

(5) Then process the remaining dimensions based on the outer circle of φ34.9 mm.

In this way, the φ4.9±0.05 mm hole is processed first, and then the other dimensions are processed on the basis of the φ4.9±0.05 mm hole, so that the drift error during the processing of the φ4.9±0.05 mm hole will be used in the subsequent processing Be corrected.